The fireproof board on the market is relatively thin and has good compactness. After pasting, the solvent in the glue that has not volatilized continues to volatilize and accumulates locally in the bonding layer area. When the accumulated pressure reaches a certain degree, the fireproof board will be jacked up, resulting in local foaming (also known as bubbling). What is the reason for the bubbling of the fireproof board? How to solve it? Let's give a brief introduction to the small editor of Beijing fumeijia fireproof board company.

原因分析

Cause analysis

①施工時膠膜未干就把面板、底板進行貼合，致使膠膜粘接力低，板中間的溶劑無法揮發造成面板起泡；

① During construction, the panel and bottom plate are bonded before the adhesive film is dry, resulting in low adhesive force of the adhesive film, and the solvent in the middle of the plate cannot volatilize, resulting in blistering of the panel;

②粘貼過程中板材間空氣沒有排除干凈；

② The air between the plates was not completely removed during the pasting process;

③涂膠時厚薄不均或缺膠，導致粘合面無膠或少膠，影響粘力。而少量未揮發盡的溶劑在揮發過程中聚集造成局部張力大于粘接力；行程小溶劑揮發速度不一致，造成厚的地方溶劑揮發不完全；

③ Uneven thickness or lack of glue during gluing, resulting in no glue or less glue on the bonding surface, affecting the adhesion. However, a small amount of non volatilized solvents gather in the volatilization process, resulting in local tension greater than adhesive force; Small stroke, inconsistent solvent volatilization speed, resulting in incomplete solvent volatilization in thick places;

④潮濕天氣施工晾膠時間不夠也容易出現起泡現象。

④ Foaming is also easy to occur due to insufficient glue drying time in wet weather construction.

預防、解決辦法

Prevention, solution

①延長晾膠時間，使膠膜中溶劑揮發完全；

① Extend the glue drying time to make the solvent in the glue film volatilize completely;

②粘貼時盡量往一邊或從中間往四周滾壓排出空氣；

② When pasting, try to roll to one side or from the middle to all sides to exhaust air;

③刮膠時盡量厚薄均勻，不出現缺膠；

③ When scraping, the thickness shall be as uniform as possible, and there shall be no lack of glue;

④可在底板上鉆出若干氣孔，增加透氣性；

④ Several air holes can be drilled on the bottom plate to increase air permeability;

⑤采用加熱的方式對膠膜加熱，提高溫度。

⑤ The adhesive film is heated by heating to increase the temperature.