墻面快裝板的安裝很多人都不太會，今天小編就來為大家介紹下墻面快裝板的安裝方法，希望能幫助到大家。

Many people are not very good at the installation of wall mounted panels. Today, Xiaobian will introduce the installation methods of wall mounted panels to you, hoping to help you.

墻面快裝板安裝步驟一：

Installation step I of wall quick mounting plate:

拼縫處應裝有密封膠，在完成前一道工序后，將被下一道工序覆蓋。

The joint shall be equipped with sealant, which will be covered by the next process after the previous process.

墻面快裝板安裝步驟二：

Installation step II of wall quick mounting plate:

富美家快裝板墻板的豎縫應采用槽形縫或工字形鋁縫。“隱蔽工程”可分為水上安裝，甚至可能危害人身安全。框架應與橫梁連接，上部隔板，外墻板和門窗框應連接。

The vertical joint of Formica quick installation panel wall panel shall adopt slot joint or I-shaped aluminum joint. "Concealed works" can be divided into water installation and may even endanger personal safety. The frame shall be connected with the beam, and the upper clapboard, exterior wall panel and door and window frame shall be connected.

然后應安裝樓板檁條，外面板應向下重疊。實際上，這種輕鋼結構用于平整圍墻和隔斷墻的基礎，更好地使用鋼筋混凝土，安裝樓梯，鋪地板，然后向上安裝一層，然后安裝屋頂桁架和屋頂面板。

Then the floor purlins shall be installed, and the outer panels shall overlap downward. In fact, this light steel structure is used to level the foundation of the fence and partition wall, make better use of reinforced concrete, install stairs, lay the floor, then install a layer upward, and then install the roof truss and roof panel.

墻面快裝板安裝步驟三：

Installation step 3 of wall quick mounting plate:

安裝門窗等，拉豎向支撐。還有就是衛生潔具啊、小五金之類的，嵌入式墻板的上下搭接縫應采用企口縫、電安裝及防潮、防水等項目。

Install doors and windows and pull vertical supports. There are also sanitary ware, hardware and so on. The upper and lower lap joints of embedded wallboards should adopt tongue and groove joints, electrical installation, moisture-proof, waterproof and other items.

其中的每一個項目都不容忽視，如果哪一個環節出了問題，都可能帶來嚴重的經濟損失，表面裝飾得再漂亮，也是徒勞；然后立柱子、墻梁或樓面次桁架的連接應使用螺栓連接。連接螺栓橫向間距應不大于500mm（每塊板寬度方向設置不少于兩個螺栓）。

Each of these projects can not be ignored. If any link goes wrong, it may bring serious economic losses. No matter how beautiful the surface decoration is, it is futile; Then the connection of vertical column, wall beam or floor sub truss shall be connected by bolts. The horizontal spacing of connecting bolts shall not be greater than 500mm (at least two bolts shall be set in the width direction of each plate).

墻面快裝板安裝步驟四：

Installation step 4 of wall quick mounting plate:

嵌入式墻板安裝應在冷彎薄壁型鋼結構安裝時及時鑲?cè)酥觾蓚?cè)槽內。

The embedded wallboard shall be inserted into the slots on both sides of the column in time during the installation of cold-formed thin-wall steel structure.

以上便是問題的相關解答內容了，如果您想獲取更多相關信息，就來關注我們網站http://www.k3037.cn吧！

The above is the relevant answers to the questions. If you want to get more relevant information, please follow our website http://www.k3037.cn Come on!